Kitchen faucet leaks at the bottom of the spout
Typical Cause
On non-pullout or non-pulldown models, a scratched or torn o-ring or rubber seal not sealing properly inside of the spout can cause a leak. If this is a pullout or pulldown model, the vacuum breaker within the spout receptor may not be sealing properly.
Solution
For non-pullout or non-pulldown faucets:
This issue should be resolved by replacing the o-ring(s) inside of the spout. The number of o-rings inside of your spout will vary depending on the model. ; different models utilize different sizes of o-rings. . We recommend lubricating the spout o-rings with silicone-based grease . Do not use plumber's grade faucet grease, silicon sprays or any lubricant that may contain petroleum. Petroleum-based lubricants may react with the rubber seals and could cause the spout to become difficult to operate. When replacing the o-rings, it is recommended that you clean the inside of the spout and the outside of the valve body.
For pullout or pulldown faucets:
Check the connection between the hose and the wand. There should be a screen washer or o-ring (depending on the model) that provides a seal between the two. If this is missing, or if it is compromised, then the screen washer or o-ring will need to be replaced.
If your model has a vacuum breaker, it may be leaking. This issue would be resolved by replacing the vacuum breaker or installing a vacuum breaker conversion kit inside of the spout receptor. This part will vary depending on the age and model of your faucet.




